I have been making wands as long as anybody in the business and the Soft Touch Trigger Valve is the ONLY trigger valve I use.
You won’t see me installing or recommending ANY other trigger valve. Period.
The Soft Touch Trigger Valve is that good.
Notice I make & sell the Soft Touch in every shape and form; far more than any other supplier.
I have sold literally thousands of these trigger valves to guys as an upgrade to the trigger valve on the wands they already own.
Once a guy tries it, he loves the easy pull and eventually he puts this same trigger valve on all of his wands.
Truly, this is the only trigger valve you need for any wand you may have.
The only problem you will have with this trigger valve is that it needs a new Rebuild kit once or twice a year.
A lot of guys don’t realize this and they will throw away the whole trigger.
Suppliers are famous for convincing you that you need to replace the whole valve when really all they need is an inexpensive rebuild kit.
Fact is, rarely do these valves go bad. I’ve seen guys get 10-12 years out of the same valve so it’s seldom the whole valve that’s bad.
It usually just needs an inexpensive rebuild kit. That’s it.
So just keep a couple of complete Rebuild kits on hand and a few Teflon Disks & Springs.
Then carefully follow the little video I made for you that shows you how to install them.
See Video
Trust me, there is a little trick to the installation you must follow to get a long life out of these parts.
So I make all these rebuild parts readily available and very inexpensive for you.
It’s the only trigger valve and the only rebuild kits you need for all your wands. The Soft Touch.
Please do not listen to other suppliers trying to sell you on their low quality trigger valves over and over and over.
These guys are con artists, plain & simple.
Just get the Soft Touch and stock up on rebuild parts and watch the video and you are set.
The Soft Touch Trigger Valve. It’s that good.
I reworked all the rebuild parts so they are the best they can be: High duromenter Viton and Deep Dish Disks.
Mark Saiger – Grand Rapids, Mn –
Send me 4 of those stainless Soft Touch valves. We’re so busy – it’s just easier for us to replace the whole valve.
Irving Rendon (verified owner) –
I ordered the stainless steel replacement valve for my wand and couldn’t be happier. It went on super easy. The whole construction is stainless steel so I know it’ll last a long time if not forever. The valve itself is super easy to use, and barely takes any effort to trigger it when wanding. Get yourself one of these your hands will thank you in the long run.
alfaprotn –
Will this fit in a standard paraplate valve mount?
Joe Bristor –
No. No offense but the Paraplate is a dinosaur of a trigger valve hanger. Heavy, bulky, 35 year old design. Chances are the wand it’s attached to is ancient too. With that said, I DO make a Paraplate trigger valve conversion.
alfaprotn –
No that wand is not near that old. Had it made for use with a paraplate. Have 3 like that. That was the only valve we did not burn through. Held up to lots of heat. Now that they are no longer made in US quality has dropped. Do you have a link for the conversion.
Joe –
Message me and I will send you a pdf of the conversion to the Soft Touch.